top of page




The VM750SH Shibata stylus cartridge is a premier 700 Series model in Audio-Technica’s new VM cartridge line - a line that harks back to A-T’s early days as a manufacturer primarily of high-end phono cartridges, while also incorporating today’s advanced technology. Like all VM cartridges, the VM750SH is equipped with dual magnets that are positioned to match the left and right channels in the stereo record groove for outstanding channel separation and extended frequency response. The cartridge’s Shibata stylus provides greater surface contact with the record groove than an elliptical stylus does, resulting in the pickup of ultra-high frequencies with less groove stress and distortion. Includes mounting hardware.





  • VM dual magnet cartridge with Shibata stylus
  • Aluminum tapered cantilever
  • Paratoroidal coils improve generating efficiency
  • Center shield plate between the left and right channels reduces crosstalk
  • Die-cast aluminum alloy housing reduces vibration and adds a natural electrical shield

Audio-Technica VM750SH Dual Moving Magnet Cartridge

  • Cartridge and Stylus


    Frequency Response: 20-27,000 Hz


    Channel Separation: 30 dB (1 kHz)  


    Vertical Tracking Angle: 23°   


    Vertical Tracking Force: 1.8-2.2 g (2.0 g standard) 


    Stylus Construction: Nude square shank 


    Recommended Load Impedance: 47,000 ohms   


    Coil Impedance: 2,700 ohms (1 kHz) 


    DC Resistance: 800 ohms 


    Coil Inductance: 460 mH (1 kHz) 


    Output Voltage: 4.0 mV (at 1 kHz, 5 cm/sec)


    Output Channel Balance:  1.0 dB (1 kHz)


    Stylus Shape: 2.7 x 0.26 mil Shibata 


    Cantilever: Aluminum tapered pipe


    Static Compliance: 40 x 10-6 cm/dyne


    Dynamic Compliance: 10 x 10-6 cm/dyne (100 Hz)


    Mounting: Half-inch


    Dimensions:  0.7"H x 0.7"W x 1.1"D


    Mounting Feature: Half-inch mount


    Recommend Load Capacitance: 100-200 pF


    Replacement Stylus: VMN50SH


    Stylus Size: 0.26 x 2.7 mil 

    Type: VM Type


    Weight: 8.0 g (0.3 oz) 


    Accessories Included: 

    Four cartridge installation screws (5 mm x 2, 10 mm x 2), two washers, two hexagon nuts, non-magnetic screwdriver, brush and lead wire set.

bottom of page